Enable PWM outputs
SD024This block issues a request to enable or disable the PWM outputs, similar to the “Enable/Disable PWM outputs” button in the Cockpit software. It issues…
SD024-
-
SBO – Sandbox output towards FPGA
The Sandbox Output towards FPGA (SBO) block writes the value of the SBO registers in the FPGA. It is used to transfer data from the…
-
SBI – Sandbox input from FPGA
The Sandbox Input from FPGA (SBI) block reads the value of the SBI registers in the FPGA. It is used to transfer data from user-made…
-
SV-PWM – Space vector PWM
The SV-PWM block generates PWM signals based on the Space Vector Modulation (SVM) algorithm. This algorithm determines the three vectors that are the closest to…
-
SB-PWM – Sandbox PWM
The FPGA sandbox PWM block allows driving the PWM output from a user-made modulator from within the FPGA. Information on FPGA edition is available on Editing…
-
DO-PWM – Direct output PWM
The Direct output PWM block sets PWM output(s) directly to ‘0’ or ‘1’. This technique is typically used for Model Predictive Control (TN162) or Direct…
-
CB-PWM – Carrier-based PWM
The carrier-based PWM block supports generating PWM signals using common digital carriers. The following configuration options are available: With sawtooth carriers, the duty-cycle and phase-shift…
-
PWM – Pulse Width Modulators
The Pulse Width Modulators (PWM) share the dead-time generation and the activate/deactivate features, configured through the output mode, deadtime, and activate parameters. The said PWM…
-
FLT – Fault inputs
At the hardware level, FLT inputs are special-purpose digital inputs that can be configured to generate a “hardware fault” in order to instantly disable all PWM outputs…
-
DEC – Angle decoder input
Imperix controllers provide angle decoder (DEC) resources to decode quadrature-encoded signals produced by incremental encoders, which are widely used in motor drive applications. At the…
End of content
End of content