CONFIG – Control task configuration
SD001The CONFIG block is mandatory and serves to: configure the main time base of the model(control task frequency) configure the ADC sampling This block also…
SD001
SD001CLK – Clock generators
SD002The B-Box RCP and B-Board PRO digital controllers hold 4 clock generators, which provide time-bases to use with various peripherals such as the PWMs and…
ADC – Analog data acquisition
SD003The ADC block is used to retrieve the measurements from the analog inputs of an imperix controller. This help documentation deals with the software part…
DAC – Analog outputs
SD004The DAC block applies a given value to one of the four analog outputs of the B-Box RCP. The corresponding hardware specifications are available in…
GPI – General purpose inputs
SD005The GPI block reads the value of the General Purpose Inputs (GPI). Simulink block Signal specification The output signal returns the value of one GPI…
GPO – General purpose outputs
SD006The GPO block sets the values of the General purpose outputs (GPO). Simulink block Signal specification The GPO pin is set if the input is…
DEC – Angle decoder input
SD007The angle decoder (DEC) block decodes quadrature-encoded signals produced by incremental encoders for motor drive applications. The B-Box RCP and B-Board PRO provide decoder inputs…
FLT – Fault inputs
SD008The FLT block configures and reads the digital fault inputs. The fault input pin signals are tied to the fault manager and, using the FLT…
PWM – Pulse Width Modulators
SD009The Pulse Width Modulators (PWM) share the dead-time generation and the activate/deactivate features, configured through the output mode, deadtime, and activate parameters. The said PWM…
CB-PWM – Carrier-based PWM
SD010The Carrier-based PWM block generates PWM signals based on one of the 4 following carrier shapes: When using the single-rate update configuration, the computed duty-cycle is synchronously applied at…
End of content
End of content