TPI ADC – Helper block
SD200The TPI ADC helper block is a wrapper that simplifies the use of the ADC block with the all-in-one programmable inverter (TPI8032 22kW). Since the…
SD200-
-
DQ-type PLL
SD035
The DQ-type PLL is a basic Phase-Locked Loop (PLL) used to extract the phase information of three-phase voltages. It operates by minimizing the voltage projected…
-
User fault – Generates a user fault
SD051
The User fault block is used to stop the converter operation from the user model. It makes the controller enters the FAULT state (user fault)…
-
LOG – Write a log message
This block writes a user-defined message in the log module of Cockpit. Numerical values can be inserted into the message using the conversion specifier “%f“,…
-
PP-PWM – Programmed Patterns PWM
The FPGA-based PP-PWM (programmed pulse pattern) peripheral provides a specialized PWM scheme for two and three-level inverters, which relies on pre-computed pulse patterns. This type…
-
BRK – Brake
The brake (BRK) block provides access to the brake control unit of the Motor Interface for B-Box RCP. The Motor Interface for B-Box RCP features a brake…
-
TRQ – Torque sensor
The torque sensor (TRQ) block reads the voltage output of a torque sensor and converts it to torque. It targets drive applications. The B-Box RCP…
-
TMP – Temperature sensor
The temperature sensor (TMP) block provides access to the temperature measurement from a PT100 or PT1000 sensor for drive applications. The B-Box RCP supports up…
-
S/C – Sin/cos encoder
The sin/cos encoder (S/C) block retrieves the Sine and Cosine signals of a sin/cos encoder connected to the Motor Interface. The B-Box RCP supports up…
-
HAL – Hall sensor input
The hall sensor interface (HAL) block provides access to the commutation signals from Hall effect sensors of a brushless DC motor. The B-Box RCP supports…
End of content
End of content