External reset
The external reset block provides a signal that can be wired to the external reset input of PID controllers to keep the integrator at reset when the target is not in OPERATING state.
The external reset block provides a signal that can be wired to the external reset input of PID controllers to keep the integrator at reset when the target is not in OPERATING state.
Benoit is an embedded systems expert and the leader of software and firmware developments at imperix. On the knowledge base, he is the author of numerous software reference documents.
The CONFIG block is mandatory and serves to: configure the main time base of the model(control task frequency) configure the ADC sampling This block also…
The B-Box RCP and B-Board PRO digital controllers hold 4 clock generators, which provide time-bases to use with various peripherals such as the PWMs and…
The ADC block is used to retrieve the measurements from the analog inputs of an imperix controller. This help documentation deals with the software part…
The DAC block applies a given value to one of the four analog outputs of the B-Box RCP. The corresponding hardware specifications are available in…
The GPI block reads the value of the General Purpose Inputs (GPI). Simulink block Signal specification The output signal returns the value of one GPI…
The GPO block sets the values of the General purpose outputs (GPO). Simulink block Signal specification The GPO pin is set if the input is…