GUI Builder module
PN304This user guide explains how to use the GUI Builder module of imperix Cockpit to interact with imperix power converter controllers, namely the B-Box 4,…
PN304-
-
Cockpit – User guide
This user guide explains how to use imperix Cockpit to interact with imperix power converter controllers, namely the B-Box 4, B-Box RCP, B-Board PRO, the B-Box…
-
CAN out – CAN output mailbox
The CAN_out block implements an output mailbox that supports sending messages using the CAN bus protocol. To receive messages, the CAN in block should be…
-
CAN in – CAN input mailbox
The CAN_in block implements an input mailbox that supports receiving messages using the CAN bus protocol. To send messages, the CAN out block should be…
-
UDP out – Ethernet UDP output mailbox
The UDP output mailbox block allows sending up to 1024 bytes of data via Ethernet using the UDP/IP protocol (in SDK versions prior to 2025.2,…
-
UDP in – Ethernet UDP input mailbox
The UDP input mailbox block allows receiving up to 1024 bytes of data via Ethernet using the UDP protocol (in SDK versions prior to 2025.2,…
-
CONFIG – Control task configuration
The CONFIG block primarily serves to configure the main clock (CLK0) as well as its derivatives. Together, these clocks define the frequency and phase of…
-
Multi-rate control on PLECS with ACG SDK
This document provides instructions on how to implement Multi-rate control on PLECS with ACG SDK. It allows running part of the control at a slower…
-
Simulation essentials with PLECS
This note provides in-depth content for an accurate and efficient offline simulation of an imperix controller and the corresponding plant model using ACG SDK on…
End of content
End of content