UDP out – Ethernet UDP output mailbox
SD019The UDP output mailbox block allows sending up to 1024 bytes of data via Ethernet using the UDP/IP protocol (in SDK versions prior to 2025.2,…
SD019-
-
UDP in – Ethernet UDP input mailbox
The UDP input mailbox block allows receiving up to 1024 bytes of data via Ethernet using the UDP protocol (in SDK versions prior to 2025.2,…
-
SV-PWM – Space vector PWM
SD013
The SV-PWM block generates PWM signals based on the Space Vector Modulation (SVM) algorithm. This algorithm determines the three vectors that are the closest to…
-
SB-PWM – Sandbox PWM
The FPGA sandbox PWM block allows driving the PWM output from a user-made modulator from within the FPGA. Information on FPGA edition is available on Editing…
-
DO-PWM – Direct output PWM
The Direct output PWM block sets PWM output(s) directly to ‘0’ or ‘1’. This technique is typically used for Model Predictive Control (TN162) or Direct…
-
CB-PWM – Carrier-based PWM
The Carrier-based PWM block generates PWM signals based on one of the 4 carrier shape illustrated below: triangle, sawtooth, inverted triangle, inverted sawtooth. When using…
-
PWM – Pulse Width Modulators
The Pulse Width Modulators (PWM) share the dead-time generation and the activate/deactivate features, configured through the output mode, deadtime, and activate parameters. The said PWM…
-
FLT – Fault inputs
The FLT block configures and reads the digital fault inputs. The fault input pin signals are tied to the fault manager and, using the FLT…
-
GPO – General purpose outputs
The GPO block, or its equivalent C++ routines, is responsible for asserting the specific logic states of the General Purpose Outputs (GPO) pins. This interface…
-
GPI – General purpose inputs
The GPI block (or its C++ routines) is responsible for reading the the logic states of the General Purpose Inputs (GPI) pins. This function allows…
End of content
End of content