This note presents a possible approach to apply pre-recorded profiles as setpoints for a control algorithm developed on Simulink with ACG SDK. It assumes the…
This product note explains how to compute the discrete control delay of a control algorithm running on an imperix controller. Context The execution of a…
This note covers the configuration and implementation of variable frequency operation with imperix controllers (B-Box RCP and B-BoardPRO). Changing the modulation frequency during the control…
This page documents the imperix firmware IP for AMD Xilinx Vivado, which is mandatory for programming the FPGA of imperix controllers. The IP encapsulates the…
This note describes how to install and get started with the imperix C++ Software Development Kit (SDK). Software installation After registration, the installer of the…
This document provides instructions on how to implement Multi-rate control on PLECS with ACG SDK. It allows running part of the control at a slower…
In voltage source converters, pre-charging the inverter DC bus is required before connecting it to external voltage sources, so that to avoid inrush currents that may be destructive.
This note provides instructions for integrating C code into a control algorithm developed using the ACG SDK via S-Functions, which is probably the best way…
This document provides instructions on how to implement Multi-rate control on Simulink with ACG SDK. It allows running part of the control at a slower…
This note provides step-by-step guidance for implementing a basic Graphical User Interface (GUI) using MATLAB App Designer. A typical application of such a GUI could…
End of content
End of content
