This page documents the imperix firmware IP for AMD Xilinx Vivado, which is mandatory for programming the FPGA of imperix controllers. The IP encapsulates the…
This document provides instructions on how to implement Multi-rate control on PLECS with ACG SDK. It allows running part of the control at a slower…
In voltage source converters, pre-charging the inverter DC bus is required before connecting it to external voltage sources, so that to avoid inrush currents that may be destructive.
This note provides instructions for integrating C code into a control algorithm developed using the ACG SDK via S-Functions, which is probably the best way…
This document provides instructions on how to implement Multi-rate control on Simulink with ACG SDK. It allows running part of the control at a slower…
Fictive axis emulation is a vector control technique that is mostly used in single-phase inverter applications, where the second axis β of a rotating reference…
This document provides instructions on how to create a control model with imperix ACG blockset, starting from a blank Simulink model. This removes the need…
This note provides tips and tricks on how to speed up Simulink simulation. 1) Avoid unnecessary continuous signals The control algorithm should be executed at…
This note provides step-by-step guidance for implementing a basic Graphical User Interface (GUI) using MATLAB App Designer. A typical application of such a GUI could…
Some power sources, like solar panels, present power characteristics that strongly depend on the operating conditions. In such cases, Maximum Power Point Tracking (MPPT) is often applied to maximize the extracted power.
End of content
End of content
