This page presents a practical example of Aurora communication with Typhoon HIL simulators, specifically the HIL101, HIL404, HIL506, and HIL606. It provides a ready-to-use user…
This page outlines the configuration methods for analog I/O channels on imperix controllers. While digital I/Os are configured exclusively via software and remain consistent across…
This article details the underlying clock architecture and timing configurations of imperix controllers, focusing on the four internal time bases (CLK0–CLK3) that govern ADC sampling,…
This article describes how to use the XY plot module of imperix Cockpit to interact with the user code running on imperix controllers, namely the…
This page presents a practical example of Aurora communication with OPAL-RT simulators, specifically the OP4510 and OP4512. It provides a ready-to-use user application, along with…
While imperix controllers are typically programmed with applications built in Simulink or PLECS, imperix also provides direct access to FPGA resources through its FPGA development…
This page presents a practical example of Aurora communication with with Plexim simulators, namely the RT-Box 1, RT-Box 2 and RT-Box 3. It provides a…
Introduction Power electronic converters pose a specific sampling challenge: the signals of interest (currents and voltages) are low-frequency components, but they are combined with a…
This page is a quick-start guide to build an interleaved boost converter using imperix equipment. It is specifically made to accompany users who want to…
This article provides getting-started instructions for first-time users of the imperix ACG SDK. It focuses on the typical workflow associated with the simulation and automated…
End of content
End of content
