CONFIG – Control task configuration
SD001This page is based on SDK 2025.2. The CONFIG block is mandatory and serves to configure the main clock CLK0, the sampling clock SCLK and…
SD001-
-
Rotor Field-Oriented Control (RFOC) of an induction machine
TN139
This note covers the rotor field-oriented control of an induction machine and its implementation on a user-configurable voltage-source inverter.
-
FPGA-based Direct Torque Control using Vivado HLS
TN133
This technical note presents an FPGA-based Direct Torque Control (DTC) of a PMSM motor using Vivado HLS, coupled with the possibility to customize the FPGA…
-
FPGA-based SPI communication IP for ADC
This technical note shows how an SPI communication link can be established between an FPGA and an external Analog-to-Digital Converter (ADC). The development setup will…
-
FPGA-based hysteresis controller for three-phase inverter using HDL Coder
This technical note shows how the implementation of an FPGA-based hysteresis controller can be conducted, starting from the modeling stage, following with automated VHDL code…
-
FPGA-based hysteresis current controller for three-phase inverter
This technical note provides an example of how a fast hysteresis current controller can be implemented, leveraging the possibility of editing the FPGA firmware for…
-
DC bus balancing of NPC converters
TN129
This technical note presents various techniques for the DC bus balancing of NPC converters. These techniques are notably used in TN135, which implements a grid-tied…
-
Sensorless motor control using a back-EMF Sliding-Mode Observer
This technical note addresses the sensorless control of motor drives using a back-EMF sliding-mode observer. The technique allows speed and position estimation of a Permanent…
-
I-f startup method for sensorless PMSM control
This note covers the I-f startup method for speed sensorless motor control and its implementation on a programmable power converter prototype.
-
V/f control of an induction machine
This note covers the V/f control of an induction machine and its implementation on a programmable drive inverter.
End of content
End of content