DO-PWM – Direct output PWM
SD011The Direct output PWM block sets PWM output(s) directly to ‘0’ or ‘1’. This technique is typically used for Model Predictive Control (TN162) or Direct…
SD011-
-
CB-PWM – Carrier-based PWM
The Carrier-based PWM block generates PWM signals based on one of the 4 carrier shape illustrated below: triangle, sawtooth, inverted triangle, inverted sawtooth. When using…
-
PWM – Pulse Width Modulators
The Pulse Width Modulators (PWM) share the dead-time generation and the activate/deactivate features, configured through the output mode, deadtime, and activate parameters. The said PWM…
-
FLT – Fault inputs
The FLT block configures and reads the digital fault inputs. The fault input pin signals are tied to the fault manager and, using the FLT…
-
DEC – Angle decoder input
The angle decoder (DEC) block decodes quadrature-encoded signals produced by incremental encoders for motor drive applications. The B-Box RCP and B-Board PRO provide decoder inputs…
-
GPO – General purpose outputs
The GPO block sets the values of the General purpose outputs (GPO). To read the value, use the GPI block. Simulink block Signal specification The…
-
GPI – General purpose inputs
The GPI block reads the value of the General Purpose Inputs (GPI). To set the value, use the GPO block. Simulink block Signal specification The…
-
DAC – Analog outputs
The DAC block applies a given value to one of the four analog outputs of the B-Box RCP. The corresponding hardware specifications are available in…
-
ADC – Analog data acquisition
The ADC block is used to retrieve the measurements from the analog inputs of an imperix controller. This help documentation deals with the software part…
-
CLK – Clock generators
This page is based on SDK 2025.2. Imperix controllers feature 4 clock generators, CLK0, CLK1, CLK2 and CLK3, running at 250 MHz. They provide time bases…
End of content
End of content