The B-Box 4 is a fully programmable controller, specifically tailored for the control of power electronics converters.
Thanks to its fast programming and its embedded protections, it is ideally suited to the experimental validation of converter control algorithms in laboratory environments.
Most imperix controllers feature 36 bidirectional 3.3V I/O lines, commonly known as USR pins. Driven directly from the FPGA, these custom-application I/Os are ideal for…
This page describes how to upgrade the imperix IP in an existing sandbox project, whether to restore compatibility with a newer SDK version or to…
Beyond the built-in modulators accessible from the user application, the imperix sandbox enables PWM generation directly within the FPGA, allowing for the implementation of custom…
Imperix provides direct access to ADC measurements within the FPGA which allows for reduced delay between the sampling and the processing, but also helps supporting…
On imperix controllers, the CPU exchanges data with the FPGA via the SBIO bus. This memory-mapped bus allows the CPU user app to read and…
This page outlines the configuration methods for analog I/O channels on imperix controllers. While digital I/Os are configured exclusively via software and remain consistent across…
This article details the underlying clock architecture and timing configurations of imperix controllers, focusing on the four internal time bases (CLK0–CLK3) that govern ADC sampling,…
This article describes how to use the XY plot module of imperix Cockpit to interact with the user code running on imperix controllers, namely the…
The EnDat block instantiates an EnDat master to communicate with compatible digital encoders and similar digital sensors, typically in motor drive applications. This block is…
The BiSS-C block instantiates a Bidirectional Synchronous Serial – Communication (BiSS-C) master to communicate with BiSS-C-compatible digital encoders and similar digital sensors, typically in motor…
End of content
End of content
