The B-Box 4 is a fully programmable controller, specifically tailored for the control of power electronics converters.
Thanks to its fast programming and its embedded protections, it is ideally suited to the experimental validation of converter control algorithms in laboratory environments.
The SFP ports on imperix controllers are typically used for interconnecting devices in a RealSync network. However, when customizing the FPGA firmware, imperix designed the…
This technical note introduces the working principles of a single phase inverter. It presents a simple technique to generate an alternating current in an open-loop…
This page provides the imperix IP and other source files required for FPGA development on imperix controllers. To learn how to use the imperix IP,…
This page presents a first HIL example to get started with a B-Box RCP and an OPAL-RT OP4510. Although validated with an OP4510, the provided…
This technical note presents a selection of the most prevalent grid synchronization methodologies employed in grid-tied power converters. These methods are crucial for enabling power…
This technical note demonstrates the control of a Doubly-Fed Induction Generator (DFIG) in a wind turbine application. Firstly, the operating principles and control strategy for…
The DIN50A block is a simulation model included in the Imperix Power library. It implements the model of the imperix ±50 A DIN rail-mountable current sensor…
The DIN800V block is a simulation model included in the Imperix Power library. It implements the model of the imperix ±800 V DIN rail-mountable voltage sensor…
The MTB block is a simulation model included in the Imperix Power library. It models the imperix motor testbench in Simulink and PLECS simulation. For more…
The PFB block is a simulation model included in the Imperix Power library. It models one symmetrical half of the imperix passive filters box in Simulink…
End of content
End of content
