This note covers the configuration and implementation of variable frequency operation with imperix controllers (B-Box RCP and B-BoardPRO). Changing the modulation frequency during the control…
This page presents a dead time selection method that can be used with imperix power modules. Appropriate dead time selection is crucial to guarantee the…
This document provides instructions on how to interface an incremental encoder with a B-Box RCP or a B-Board PRO and how to read the motor…
This page documents the imperix firmware IP for Xilinx Vivado, which contains the imperix FPGA logic of the imperix controllers, namely the B-Box RCP, the B-Board PRO,…
This note provides step-by-step guidance to create a Xilinx Vivado project, add customized logic, generate a bitstream, and load it into the B-Box/B-Board. The required…
This note describes how to install and get started with the imperix C++ Software Development Kit (SDK). Software installation After registration, the installer of the…
In voltage source converters, pre-charging the inverter DC bus is required before connecting it to external voltage sources, so that to avoid inrush currents that may be destructive.
Fictive axis emulation is a vector control technique that is mostly used in single-phase inverter applications, where the second axis β of a rotating reference…
This note provides step-by-step guidance for implementing a basic Graphical User Interface (GUI) using MATLAB App Designer. A typical application of such a GUI could…
Some power sources, like solar panels, present power characteristics that strongly depend on the operating conditions. In such cases, Maximum Power Point Tracking (MPPT) is often applied to maximize the extracted power.
End of content
End of content
