The Pulse Width Modulators (PWM) share the dead-time generation and the activate/deactivate features, configured through the output mode, deadtime, and activate parameters. The said PWM…
The FLT block configures and reads the digital fault inputs. The fault input pin signals are tied to the fault manager and, using the FLT…
The angle decoder (DEC) block decodes quadrature-encoded signals produced by incremental encoders for motor drive applications. The B-Box RCP and B-Board PRO provide decoder inputs…
The GPO block sets the values of the General purpose outputs (GPO). To read the value, use the GPI block. Simulink block Signal specification The…
The GPI block reads the value of the General Purpose Inputs (GPI). To set the value, use the GPO block. Simulink block Signal specification The…
The DAC block applies a given value to one of the four analog outputs of the B-Box RCP. The corresponding hardware specifications are available in…
The ADC block is used to retrieve the measurements from the analog inputs of an imperix controller. This help documentation deals with the software part…
This page is based on SDK 2025.2. Imperix controllers feature 4 clock generators, CLK0, CLK1, CLK2 and CLK3, running at 250 MHz. They provide time bases…
This page is based on SDK 2025.2. The CONFIG block is mandatory and serves to configure the main clock CLK0, the sampling clock SCLK and…
This technical note presents an FPGA-based Direct Torque Control (DTC) of a PMSM motor using Vivado HLS, coupled with the possibility to customize the FPGA…
End of content
End of content
