The B-Box 4 is a fully programmable controller, specifically tailored for the control of power electronics converters.
Thanks to its fast programming and its embedded protections, it is ideally suited to the experimental validation of converter control algorithms in laboratory environments.
This note presents a possible approach to apply pre-recorded profiles as setpoints for a control algorithm developed on Simulink with ACG SDK. It assumes the…
This product note explains how to compute the discrete control delay of a control algorithm running on an imperix controller. Context The execution of a…
This note covers the configuration and implementation of variable frequency operation with imperix controllers (B-Box RCP and B-BoardPRO). Changing the modulation frequency during the control…
Dead time is a brief non-conduction interval imposed across two complimentary PWM signals to prevent a potentially damaging shoot-through inside the corresponding switching cell. Dead…
This document provides instructions on how to interface an incremental encoder with a B-Box RCP or a B-Board PRO and how to read the motor…
This page documents the imperix firmware IP for Xilinx Vivado, which contains the imperix FPGA logic of the imperix controllers, namely the B-Box RCP, the B-Board PRO,…
This note provides step-by-step guidance to create a Xilinx Vivado project, add customized logic, generate a bitstream, and load it into the B-Box/B-Board. The required…
This note describes how to install and get started with the imperix C++ Software Development Kit (SDK). Software installation After registration, the installer of the…
This document provides instructions on how to implement Multi-rate control on PLECS with ACG SDK. It allows running part of the control at a slower…
In voltage source converters, pre-charging the inverter DC bus is required before connecting it to external voltage sources, so that to avoid inrush currents that may be destructive.
End of content
End of content
