Timing info tab in BB Control
PN156The BB Control Timing info tab provides a graphical representation of the various computation and communication delays involved in the B-Board PRO and B-Box RCP…
PN156-
-
SCLK multiplier configuration and utilization
In a standard configuration, the control algorithm executes immediately following each sampling event. The SCLK multiplier modifies this behavior by allowing multiple sampling events to…
-
Applying pre-recorded profiles as setpoints
PN152
This note presents a possible approach to apply pre-recorded profiles as setpoints for a control algorithm developed on Simulink with ACG SDK. It assumes the…
-
Discrete control delay identification
This product note explains how to compute the discrete control delay of a control algorithm running on an imperix controller. Context The execution of a…
-
Variable frequency operation with imperix controllers
This note covers the configuration and implementation of variable frequency operation with imperix controllers (B-Box RCP and B-BoardPRO). Changing the modulation frequency during the control…
-
Dead time selection for imperix power modules
PN115
Dead time is a brief non-conduction interval imposed across two complementary PWM signals to prevent a potentially damaging shoot-through inside the corresponding switching cell. Dead…
-
Using the angle decoder modules
This document provides instructions on how to interface an incremental encoder with a B-Box RCP or a B-Board PRO and how to read the motor…
-
Product guide of the imperix firmware IP
This page documents the imperix firmware IP for AMD Xilinx Vivado, which is mandatory for programming the FPGA of imperix controllers. The IP encapsulates the…
-
Installation and use of the CPP SDK
This note describes how to install and get started with the imperix C++ Software Development Kit (SDK). Software installation After registration, the installer of the…
-
Multi-rate control on PLECS with ACG SDK
PN155
This document provides instructions on how to implement Multi-rate control on PLECS with ACG SDK. It allows running part of the control at a slower…
End of content
End of content