CAN out – CAN output mailbox
SD017The CAN output mailbox block allows sending CAN messages with up to 8 bytes long payloads. It supports two operating modes: On-demand mode: the user…
SD017
SD017SBI – Sandbox input from FPGA
SD022The Sandbox Input from FPGA (SBI) block reads the value of the SBI registers in the FPGA. It is used to transfer data from user-made…
SBO – Sandbox output towards FPGA
SD023The Sandbox Output towards FPGA (SBO) block writes the value of the SBO registers in the FPGA. It is used to transfer data from the…
Enable PWM outputs
SD024This block issues a request to enable or disable the PWM outputs, similar to the “Enable outputs” button of BB Control utility software. It issues…
External reset
SD025The external reset block provides a signal that can be wired to the external reset input of PID controllers to keep the integrator at reset…
Core state
SD026The Core state block returns the state of the target: 0 = FAULT: The target received an error signal and waits for a user acknowledgment…
Probe variable
SD027The probe variable block creates a variable that can be watched and logged in real-time using using imperix Cockpit. It supports the int32, uint32, and…
Tunable parameter
SD028The tunable parameter block creates a variable that can be altered in real-time using imperix Cockpit. It supports the int32, uint32, and float data types. Simultaneously, the tunable parameter…
Synchronous reference frame (SRF) PLL
TN103This note provides insights into the operating principle of a synchronous reference frame PLL (SRF PLL), also known as DQ-type PLL. An implementation of an…
NPC inverter for three-phase applications
TN135Neutral Point Clamped NPC converters are a family of multilevel power converters that are characterized by the use of clamping diodes for guaranteeing the proper voltage sharing across the power switches.
End of content
End of content