The B-Box 4 is a fully programmable controller, specifically tailored for the control of power electronics converters.
Thanks to its fast programming and its embedded protections, it is ideally suited to the experimental validation of converter control algorithms in laboratory environments.
The SS-PWM peripheral provides a specialized Pulse Width Modulation scheme (PWM) for multilevel converters, which directly integrates means for balancing series-connected submodules. Such an approach…
This technical note offers insights into the SS-PWM peripheral block, which is part of the standard firmware of imperix controllers. The SS-PWM block provides multilevel…
This technical note describes the operating principles of a buck-boost converter. A possible open-loop control implementation of this converter, targeting the B-Box RCP or B-Board PRO with both C/C++ and automated code…
This technical note describes the operating principles of a step-up boost converter. A possible open-loop control implementation of this converter, targeting the B-Box RCP or B-Board PRO with both C/C++ and automated…
This technical note describes the operating principles of a step-down buck converter. A possible open-loop control implementation of this converter, targeting the B-Box RCP or B-Board PRO with both C/C++ and automated…
This technical note shows how to build a decoder IP for a Delta-Sigma Modulator and establish communication with such a device through USR ports of…
What is the difference between Space Vector (SVPWM) and Sinusoidal Pulse Width Modulation (SPWM)? This article presents the advantages of the SVPWM technique over SPWM…
This quick-start guide describes how to build a buck converter controlled in open-loop using power modules and the B-Box RCP 3.0 programmable controller using the…
The choice of fixed vs floating-point arithmetic for an FPGA algorithm is a decision that has a significant impact on the FPGA resources usage, computation…
This page provides step-by-step guidance to install Xilinx Vivado Design Suite, the tools used to program the FPGA of imperix controllers.
End of content
End of content
