These pages give getting-started instructions and practical examples for customizing the FPGA firmware of the B-Box RCP or B-Board PRO. This allows offloading computations to the FPGA and developing specialized functions for very high-performance control algorithms.
This note describes the control of an adapted Siemens SINAMICS S120 active line module using the imperix B-Board PRO embedded control platform. With its low…
An introduction to Aurora communication with third-party devices is available in SFP communication with third-party devices. The current page extends that overview by presenting a…
While imperix controllers are typically programmed with applications built in Simulink or PLECS, imperix also provides direct access to FPGA resources through its FPGA development…
An introduction to Aurora communication with third-party devices is available in SFP communication with third-party devices. The current page extends that overview by presenting a…
The SFP ports on imperix controllers are typically used for interconnecting devices in a RealSync network. However, when customizing the FPGA firmware, imperix designed the…
This page provides the source files, namely the imperix firmware IP and project template creation script, to start programming the FPGA on imperix devices. After…
This technical note shows how to build a decoder IP for a Delta-Sigma Modulator and establish communication with such a device through USR ports of…
The choice of fixed vs floating-point arithmetic for an FPGA algorithm is a decision that has a significant impact on the FPGA resources usage, computation…
This page provides step-by-step guidance to install Xilinx Vivado Design Suite, the tools used to program the FPGA of imperix controllers.
Control algorithms for power electronics converters often rely on PI controllers executed on the CPU of the controller. That’s the technique used in most of…
End of content
End of content
